LPR Cameras: Siram Totem
The strongest
SIRAM capture unit for number plate recognition, consisting of an IP camera (CMOS Mpixel sensor), varifocal lens, outdoor cabinet of 700mm in painted stainless steel, glass and IR light of 196 or 266 leds (depending on version).
For accesses with lane width over 3m
Capture distances over 6m
Ideal to avoid vandalism


LED
LED lights for a better view

Anti-vandalism
To avoid acts of vandalism

Trucks
Ideal for big vehicles

Parking
To use in parkings
Recommended Type of facility
This capture unit model is especially suitable for access points with widths greater than 3 metres, with capture distances of more than 6 metres and in unattended environments. The design of the SIRAM TOTEM capture unit is ideal for preventing vandalism
MINIMUM DISTANCE TO NUMBER PLATE: 2,5m.
MAXIMUM DISTANCE TO NUMBER PLATE: 8m.


Recommended applications
- Public Parking
- Corporate Residential
- Shopping Center
- Airports and Ports
- Border posts
- Industrial Access points
SIRAM Totem versions
This capture unit model is supplied in 8 different versions depending on the number of leds for the IR light (196 or 266), and whether it is supplied jointly with the control electronics machined in an additional electrical board.
SIRAM TOTEM | Number of Leds | SIRAM CONEX Electronics | Loop detector |
---|---|---|---|
SIRAM TOTEM | 196 | — | — |
SIRAM TOTEM CONEX IP | 196 | 1 | — |
SIRAM TOTEM CONEX IP01 | 196 | 1 | 1 |
SIRAM TOTEM CONEX IP02 | 196 | 1 | 2 |
SIRAM TOTEM L | Number of Leds | SIRAM CONEX Electronics | Loop detector |
---|---|---|---|
SIRAM TOTEM L | 196 | — | — |
SIRAM TOTEM L CONEX IP | 196 | 1 | — |
SIRAM TOTEM L CONEX IP01 | 196 | 1 | 1 |
SIRAM TOTEM L CONEX IP02 | 196 | 1 | 2 |
Location of SIRAM Totem in the access point
The positioning of the capture unit with regard to the ground must always meet the following requirements:
– The smallest horizontal and vertical angle possible with respect to the centre of the number plate. The maximum recommended angle is 30 degrees, the smaller this angle the greater will be the reflection of the IR light.
– When the vehicle is captured it must be properly in the lane: if when the vehicle is captured it is turning and the capture unit is located on the wrong side, the camera cannot see the number plate. It is always necessary to seek the most perpendicular position for the camera in terms of the number plate.
– At the time of capture or trigger, the characters of the plate must be between the “Minimum Size” and “Maximum Size” shown in SIRAM OCR in the toolbox.
– If the capture is performed using a software or hardware trigger, it is necessary to take into account the concealment produced when vehicles travel in convoy.

Download our catalogue
Some of our success stories




Do you want to know more?
Give us your details and we will call you: