LPR Cameras: Siram Totem Compact
SIRAM capture unit for number plate recognition, consisting of an IP camera (CMOS Mpixel sensor,
varifocal lens, outdoor cabinet of 700mm in painted stainless steel, glass and IR light of 168 leds.
Capture distances lower than 6m
Suitable to prevent vandalism
Recommended in traffic islands with little space
LED lights for a better view
To prevent acts of vandalism
To use in parkings
Ideal for big vehicles
Recommended Type of facility
This model is particularly recommended for access points with little space for the positioning of the capture unit. The lane width must be less than 3 metres and the capture distance less than 6 metres. The design of the SIRAM TOTEM COMPACT capture unit is ideal for preventing vandalism.
MINIMUM DISTANCE TO NUMBER PLATE: 2 m.
MAXIMUM DISTANCE TO NUMBER PLATE: 6 m.
- Public Parking
- Corporate Residential
- Shopping Center
- Airports and Ports
- Border posts
SIRAM Totem Compact versions
This capture unit model is supplied in 4 different versions depending on whether it is supplied jointly with the control electronics machined in an additional electrical board.
|Number of leds||SIRAM CONEX electronics||Loop detector|
|SIRAM TOTEM COMPACT||168||—||—|
|SIRAM TOTEM COMPACT CONEX IP||168||1||—|
|SIRAM TOTEM COMPACT CONEX IP01||168||1||1|
|SIRAM TOTEM COMPACT IP02||168||1||2|
Location of SIRAM Totem Compact in the access point
The positioning of the capture unit with regard to the ground must always meet the following requirements:
– The smallest horizontal and vertical angle possible with respect to the centre of the number plate. The maximum recommended angle is 30 degrees, the smaller this angle the greater will be the reflection of the IR light.
– When the vehicle is captured it must be properly in the lane: if when the vehicle is captured it is turning and the capture unit is located on the wrong side, the camera cannot see the number plate. It is always necessary to seek the most perpendicular position for the camera in terms of the number plate.
– At the time of capture or trigger, the characters of the plate must be between the “Minimum Size” and “Maximum Size” shown in SIRAM OCR in the toolbox.
– If the capture is performed using a software or hardware trigger, it is necessary to take into account the concealment produced when vehicles travel in convoy.
Download our catalogue
Some of our success stories
Do you want to know more?
Give us your details and we will call you: